« Return to Thread: Wireless & Bonding with ARP link monitoring

Wireless & Bonding with ARP link monitoring

by Erdenebayar Buriad :: Rate this Message:

Reply to Author | View in Thread

Some parts of this message have been removed. Learn more about Nabble's security policy.

Hi folks

I have problem, bonding with ARP link monitoring.

My testbed is simple, only two mobile nodes with 2 wireless interfaces, each node.

I planned to demonstrate bonding technology with ARP link monitoring, bonding mode 0 (balance-rr).

When I use MII monitoring for bonding, It was OK (bonding mode: 0,1,2,3).

But when I tried bonding with ARP link monitoring, It seams to be some problem. There was not any connection between nodes (between bonded interfaces). Each nodes sending ARP packets.

Also, I have not any bonding error message when I configure bonding driver and interface.

Status bonding is DOWN in the "/proc/net/bonding/bond0".

I used this command on both nodes : "modprobe bonding mode=2 arp_interval=1000 arp_ip_target=10.0.0.1"

---------

I am using Wireless interface: PRISM 3 chipset based wireless cards

driver : Hostap 0.4.7 (also I tried 0.4.9) and hostap-util 0.4.7

linux kernel -2.6.13.5 (RHEL 4)

---------

Have you any idea, please ?

Regards,

Bayaraa

_______________________________________________
Bond-users mailing list
Bond-users@...
http://hcoop.net/cgi-bin/mailman/listinfo/bond-users

« Return to Thread: Wireless & Bonding with ARP link monitoring

LightInTheBox - Buy quality products at wholesale price!