Thecus N2100 could not load module after redboot back to thecus firmware

[thomas winter-2]

Hi,
after trying to get booted by disk label I lost my box.

I did redboot and load Thecus firmware.
Everything fine except that I can not install ssh module.
In firmware 05 there was after upload only an blank page, in firmware 09 the
page showed up but no modules are listed.

Any idea what happened here and how I get back to debian.

The box is an ALLNET box and modified to thecus. Without debian ist an brick
for me.

best regards
Thomas


--
To UNSUBSCRIBE, email to debian-arm-REQUEST@...
with a subject of "unsubscribe". Trouble? Contact listmaster@...

[Tobias Frost]

Redboot again and load the debian installer image. (See my blog blog.coldtobi.de
for a howto. )
(If that's what you want. Or do you want to chroot?)

Tobi


On Sun, 2008-06-08 at 18:19 +0200, Thomas Winter wrote:

> Hi,
> after trying to get booted by disk label I lost my box.
>
> I did redboot and load Thecus firmware.
> Everything fine except that I can not install ssh module.
> In firmware 05 there was after upload only an blank page, in firmware 09 the
> page showed up but no modules are listed.
>
> Any idea what happened here and how I get back to debian.
>
> The box is an ALLNET box and modified to thecus. Without debian ist an brick
> for me.
>
> best regards
> Thomas
>
>

--
To UNSUBSCRIBE, email to debian-arm-REQUEST@...
with a subject of "unsubscribe". Trouble? Contact listmaster@...

[thomas winter-2]

On Sunday 08 June 2008 20:29, Tobias Frost wrote:
> Redboot again and load the debian installer image. (See my blog
> blog.coldtobi.de for a howto. )
> (If that's what you want. Or do you want to chroot?)

thanks, with debian installer it can install an new system
regards
Thomas


--
To UNSUBSCRIBE, email to debian-arm-REQUEST@...
with a subject of "unsubscribe". Trouble? Contact listmaster@...