Hi Corry,
> Do I need to remove any resistors on the console-vx board to use the TTL
> voltage level UART serial ports.
Yes. Otherwise you will have the on-board voltage converter and
whatever is driving the Rx signal external trying to fight with each
other.
> I saw this on the Wiki page and I am not sure if this is necessary. I am
> getting some bad signals off the RX pin on the STUART.
Exactly because the resistor is still present.
--
Dave Hylands
Vancouver, BC, Canada
http://www.DaveHylands.com/-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/_______________________________________________
gumstix-users mailing list
gumstix-users@...
https://lists.sourceforge.net/lists/listinfo/gumstix-users
