Actually the support bearing is two large bearings for support. The
motor in the adaptor spins very smoothly and in the vehicle it spins
smoothly. Built very solid. More solid than needed. You are correct
that it is not a Jack Heintz but then again this kit was designed to
use the available generator/starter motors and they all bolt right up
and all have the same kind of connections to wire it up.
Pete
On May 15, 2008, at 2:17 PM, ampaynz1 wrote:
> The kalylor kit comes
> with a support bearing that connects to spline shaft on the inside
> and on
> the outside the other part bolts to the flywheel. Very nicely done in
> converting a motor into another purpose other the airplane use.
_______________________________________________
For subscription options, see
http://lists.sjsu.edu/mailman/listinfo/ev
