Re: Custom WiFi Board

> -----Original Message-----
> From: gumstix-users-bounces@... [mailto:gumstix-users-
> bounces@...] On Behalf Of voorhies
> Sent: Wednesday, May 21, 2008 9:57 PM
> To: gumstix-users@...
> Subject: [Gumstix-users] Custom WiFi Board
>
>
> I just created a custom carrier board for my Verdex XL6P based off of the
> netwifimicroSD eagle schematics that are posted, and am having trouble
> with
> the Marvell WiFi module.  I removed the LAN9117 and RJ45 jack from the
> schematics, but otherwise left them pretty much intact, adding only a
> Propeller, some motor drivers and a few other things here and there that
> are
> completely unrelated to the bus that the WiFi module is on. I've gone over
> all of the obvious problem points (solder connections, etc..) and
> everything
> checks out, so I seem to have done something fundamentally wrong. The only
> other difference is that I had to use the TI WAH4245 instead of the WB4245
> as the level translators because I couldn't find the WB anywhere, but a
> look
> at the datasheets tells me that they should be equivalent.  Does the wifi
> module rely on the LAN9117 chip at all? Has anyone had any successes
> creating their own wifi boards?
>
> Thanks!
>   Rand
> --
> View this message in context: http://www.nabble.com/Custom-WiFi-Board-
> tp17395890p17395890.html
> Sent from the Gumstix mailing list archive at Nabble.com.
>
>
> -------------------------------------------------------------------------
> This SF.net email is sponsored by: Microsoft
> Defy all challenges. Microsoft(R) Visual Studio 2008.
> http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
> _______________________________________________
> gumstix-users mailing list
> gumstix-users@...
> https://lists.sourceforge.net/lists/listinfo/gumstix-users