> Current draw on +-12 V is only a few mA.
Was that measurement on +12V done with the AUI Ethernet connected to a
transceiver? I think AUI Ethernet needs +12V, but could be wrong.
(Also, if you're using an AUI multiport, it may not be drawing on +12V
from the AUI connector.)
I should dig out one of mine and do some experimenting - see what goes
dead when I cut various voltages.
> Pins C and D on the 6 pin connector are in deed Csync. (One pin is
> GND, the other is the usual TTL level sync.)
Which is which?
> Once I connected this Csync and the video signals from the RCA plug
> to a monitor and got video output from the ELC on the screen.
Thank you for all the info. I've updated my local copy of the page.
Either I've forgotten how I used to update the sunhelp copy or the
access has stopped working, so I can't do the update; I'll be
contacting Mr. Bill about that offlist.
/~\ The ASCII der Mouse
\ / Ribbon Campaign
X Against HTML
mouse@...
/ \ Email! 7D C8 61 52 5D E7 2D 39 4E F1 31 3E E8 B3 27 4B
_______________________________________________
rescue list -
http://www.sunhelp.org/mailman/listinfo/rescue
