Hi,
Been a while since I posted. Anyway, I am designing a board
in Eagle, and when I do an ERC check on the schematic I get
this error.
SUPPLY pin GND overwritten with more than one signal(H-GND,
GND)
I changed the net class for those pins to be H-GND for a
heavier trace width. I am not sure where it's getting the
GND signal from ?
I tried the archives and google, etc... but no luck. I basically
have the GND pins on the M33887
chip tied to a GND symbol and then changed the net class to
H-GND so that it has the track width set at 60 mils with 15
mils of clearence.
Thanks,
Kevin
--
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
